Loba- Argo 6.5oz

• For professional use only!
• BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
• For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
• Recommended conditions are 55°F-80°F/40-75%rH.
• Sand and prepare floors according to NWFA guidelines.
• ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
• Shake material well before use.
• Do not thin. Do not add water.
• Do not apply at temperatures below 55°F (13°C). Make sure material is at room temperature. Always maintain adequate ventilation during all phases of the coating and drying process.
• Apply evenly at the recommended coverage rate. Avoid streaks, puddles, and lap marks.

Drying time

• • The drying time of mixed finishes will increase.
  • A recoating will be possilbe after 6-8 hours.
  • Can be carefully walked on after 6-8 hours.
  • Light wear after 24 hours.
  • Reaches final hardness after approx. 8 days.

Recommended Procedure for wood floors:

• Add Argo only right before the application by shaking or stirring thoroughly. When using 2-component-systems (2K Duo, 2K Supra A.T.) add Argo only AFTER adding hardener to the mass!
• Perform application according to Technical Information of the finish, regard pro-longed drying times.
• 1K finish mixed with LOBA Argo must be applied within 24 hours, 2K finishes within the indicated application time.
• Longer stability is not guaranteed.
  Can be combined with all LOBA water-based finishes and primers. The application properties of the finish, its product combinability, and the drying time remain unchanged. Refer to the Technical Data Sheet of the corresponding finish.