- For professional use only!
- Filter material before use.
- BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
- BEFORE USING, READ, UNDERSTAND, AND FOLLOW ALL SAFETY INSTRUCTIONS GIVEN BY THE UV-MACHINE MANUFACTURER.
- For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
- Recommended conditions are 55°F-80°F/40-75%rH.
- Sand and prepare floors according to NWFA guidelines.
- ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
- Shake material well before use.
- Do not thin. Do not add water.
- Do not apply at temperatures below 55°F (13°C). Make sure material is at room temperature. Always maintain adequate ventilation during all phases of the coating and drying process.
- Apply evenly at the recommended coverage rate. Avoid streaks, puddles, and lap marks.
- The UV-curing process is carried out with an UV-curing unit, with a capacity of approx. 3000watt/ozone-free. In order to achieve a full curing a light intensity of at least 300mJ/cm² has to be achieved. For example with the DecoRad® Floormate. At a speed of 8m/min (08.0 on Display).
- Rush reacts when exposed to light. The container has to be closed immediately after use.
- Before the operation of the UV-curing unit all safety instructions from the machine manufacturer must be observed. The working area has to be marked visibly for everyone and should be sectioned off.
- The use of specific safety goggles or safety visors is required; UV-light can cause vision damage.
- cover exposed skin.
- This product is part of the LOBA and Wakol “Connected Systems”. The approved combinations with Wakol wood flooring adhesives may be found in the "Connected Systems Matrix": https://www.loba.de/us/connected-systems/
Application Tool
LOBA Roller Universal 100T-barMobile UV lamp e.g. DecoRad® Floormate
Coverage
400-500 square feet per gallon per coat.
Drying time
- Can be carefully walked on after 3 hours.
- Earliest possible UV-light curing after 3 hours.
- Intermediate sanding immediately after UV curing.
- Final hardness immediately after UV curing.
- If there is a delay in drying wait until you can see that the surface is completely dry.
Recommended Procedure for re-coating of wood floors:
Always perform the “cross Hatch” test and the “cointest” test for adhesion on a test area of existing finish prior to full scale application.
Application:
- Remove all wax, oil, grease and dirt by deep cleaning the floor with LOBA Remover (follow instructions on the Technical Data Sheet of Remover)
- Perform intermediate sanding with LOBASAND perforated pad 180 (or equivalent). Vacuum floor then tack using a LOBA Mop and a new/clean LOBA microfiber mop pad lightly dampened with water to remove all dust.
- Apply Rush
- Let dry 3 hours
- Light-cure with a UV-curing unit @ 300mJ/cm²
